Hose Clips

8 products

Jubilee hose clips secure flexible ducting to fan spigots, rigid duct, fittings and terminals so the joint stays tight and air tight. We stock 430 stainless steel worm-drive Jubilee clips in 100mm, 125mm, 150mm, 175mm and 203mm, HC range clip packs of 10 covering 100mm to 520mm, 30 metre rolls of HCB clip band and QRL quick release locks for making clips to any length. Use the buttons below to filter by size, or for help, email hello@efans.co.uk or call 0161 399 3825.

Frequently asked questions

What size hose clip do I need?

Match the clip to the outside diameter of the joint. For flex on a spigot, that is the outside of the flex once it is pushed over the spigot, which is a little larger than the nominal duct size. If you are between sizes, go up one.

Do I need a clip on every flexible duct joint?

Yes. A push fit alone will not hold flexible ducting securely, so clip every joint where flex meets a spigot, fan, valve or terminal. Tape the joint as well if it needs to be fully air tight.

What are clip band and quick release locks for?

HCB clip band comes in a 30 metre roll that you cut to length, and QRL locks turn each piece into a quick release clip. They are ideal for unusual sizes, very large ducts or joints that need to come apart for regular maintenance.

What are the clips made from?

The individual Jubilee clips are 430 stainless steel, 9mm wide with a 0.6mm band, with a tilting head so you can clamp by hand then tighten with a screwdriver or hex driver. For trade quantities, email hello@efans.co.uk or call 0161 399 3825.

100mm 125mm 150mm 175mm 203mm